🔥FREE SHIPPING on all orders over $200!📦

Your Cart is Empty


OnTheFly Jackplate - Electric

Electric On The Fly Jack Plate is the quietest jack plate on the market. 



Our jack plates can be raised and lowered by an up/down push button while on the water within seconds from top to bottom. We have made it simple for YOU! Just mount the jack plate, connect it to the battery with our easy quick connectors, and go!

  • Standard size is approved for up to 40hp motors (for motors without factory trim and tilt or standard BIA bolting pattern)
  • Large size is approved for motors up to 90hp(for motors with factory trim and tilt or standard BIA bolting pattern)
  • Works with 0-20hp motors with electric trim and tilt
  • Our  electric actuator mounts inside the jack plate housing
  • 3 year warranty on the jack plate housing
  • 1 year warranty on the electric actuator
  • Pre-drilled for transom mounting (transom side pre-drilled holes are 8 inches across and 8 1/4 inches down from each other)
  • The Electric Standard On The Fly Jack Plate is easy to install and connect wires to the battery. It comes with easy weatherproof connecters. All you have to do is just push the 2 connectors together once you have your relay harness hooked up to the battery and your new jack plate is working.
  • Jack Plate housing made is the USA.

WEIGHT: 23lbs

• Height – 10 1/2”
• Width (Transom Side) – 12 ½”
• Width (Motor Side) – 13 ¼”
• Set Back – 5” (total length from of transom side to the back of the motor slide)
• Motor Plate Height – 12 ½”
• Motor Mounting Plate (Inside Brackets where the motor would mount) – 10 ¾”

MAX RISE (travel): 6 inches of travel. Plus, depending on where you mount the electric actuator you can get up to 8 inches of rise.

ACCESSORIES INCLUDED: Jack plate housing, On The Fly Electric Actuator, Up/Down switch, relay harness, and 10 feet of wiring from the electric actuator and up/down switch to the battery.

ACCESSORIES NOT INCLUDED: Transom mounting accessories are not included in purchase. On The Fly Jack Plates recommends
• 4 each ½”- 3 1/2” long bolts – stainless steel
• 4 each ½”- lock nuts – stainless steel
• 8 each 1/2’”-flat washers – stainless steel
• Motor Clamp Spacers

• 3 year warranty on the jack plate housing
• 1 year warranty on the jack

OnTheFlyJackplates Info

Customer Reviews

Based on 1 review
Derek Peterson
Excellence all around

I've been wholeheartedly impressed by the people at OnTheFly, I had a few issues along the way with my install and they were super urgent in helping me out and getting things working again. Now that everything is running it's hard to believe how quiet this all works, even with the engine off it's hard to tell it's operating other than how fast it actually operates.

For anyone installing themself make sure you don't miss that there is a small washer at 1 end of the bar spanning the bottom, and that you need to keep things clamped tight while setting up your holes in the transom. This is well documented in the instructions. Make sure you read them word for word though and you'll be off to the shallows and enjoying better holeshot in no time ;)